Fort Worth Motorcycle Riders

I've been wanting to put a fender eliminator on my Ninja for while now but, I couldn't justify $60 for it.
So I decided it was time for me to cut it off. I know it's not perfect but I think it looks a lot better
I still have a little bit of trimming to do but I can always take more of the plastic off.. But I can't put it back on once I take it off.

I installed that same eliminator on my Versys.

Did the same on my Suzuki, Autozone weather stripping to clean up the edge....

Looks good, I did one similar on the Katana, except went flush to the tail and used a blowtorch to clean up the edges, then built a bracket out of sheet metal for the plate and blinkers.

Firewa11 wrote:Looks good, I did one similar on the Katana, except went flush to the tail and used a blowtorch to clean up the edges, then built a bracket out of sheet metal for the plate and blinkers.

Sounds good.. I might do that later.