New taillight/blinkers installed

[Polokid69]

Just got finished with the new tail/ integrated signal light installation

[fixxervi6]

Is this going to be the worlds most expensive zzr?

I hope in 6 months you don't decide to go to a zx6r

[Polokid69]

Is this going to be the worlds most expensive zzr?

I hope in 6 months you don't decide to go to a zx6r

Just a little clean up. Flush mounts and integrated tail is all I'm doing. Would like to clean the tail up with a fender eliminator but that's it

[milesmiles]

Looks good. I like

[Polokid69]

Thanks Miles!

[Striple]

Looks good! Don't forget to upgrade the rider!

[DemonDuck]

I do like it. Looks great.

[Polokid69]

Looks good! Don't forget to upgrade the rider!

working on it

[Polokid69]

looks like it will be an ordeal to remove that rear fender ! seems like its connected to half the bike!

[Firewa11]

My old Katana was like that, I had to dremel it off following along the tail. Just make sure you wear safety glasses, molten plastic in the eye is not recommended. Looking great so far!!!

[DarcShadow]

A hack saw will work better, then the dremel to clean it up, or even a good knife can do the cleanup.

[Firewa11]

Dremel worked best because I didn't have to take it off the bike. Then built my own undertail kit (simple bracket) for the license plate.

[Dragonfly]

Is this going to be the worlds most expensive zzr?

I hope in 6 months you don't decide to go to a zx6r

Just a little clean up. Flush mounts and integrated tail is all I'm doing. Would like to clean the tail up with a fender eliminator but that's it

The undertail is a large piece, If you can find one. You have to search for 2000-2002 zx6r models, not 2007 ZZR's. Or, you can do what I did. Use a very sharp knife to cut off the fender. Sharp knife leaves a cleaner look to the original undertail than a dremel and cutoff wheel. Plus its nowhere near as messy.

[Polokid69]

http://www.hotbodiesracing.com/en/prod_ ... -08_zzr600" onclick="window.open(this.href);return false;

[Dragonfly]

Nice!

[milesmiles]

Those blinkers look even better in person! Making me want to go buy some myself

[Polokid69]

It's was reasonable upgrade and took 30 min tops

[Polokid69]

I hate stalks !

[Polokid69]

Nice!

I had Scott do it at Cycle Werkz. I found it was worth it to pay someone to do it right and right now my time with my daughter is more valuable that spending hours installing myself. Just got back from shop and it looks fantastic! I'll post pics later when I pick up bike and you can give me your opinion.

[U-Turn]

Good to have a professional do something like that. So many people forget the blinker fluid.

[milesmiles]

True that!

[Polokid69]

Good to have a professional do something like that. So many people forget the blinker fluid.

I made sure they used synthetic blinker fluid

[Polokid69]

Cycle Werkz has finished my bike.

[Polokid69]

Before and after

[dufremle]

Nice!