Anyone with a drill press?

[DemonDuck]

If someone has a drill press and a 7/8 drill bit that we can use to cut into the plastic cover plate for my headlights I would really appriciate it.

[nitzer]

I do, but it's down in Austin...

[russian]

i have one at chris's house in white settlement

[2track]

I have a drill press but no 7/8 bit. I have a 7/8 paddle bit though.

[Firewa11]

Tape both sides of the plastic before drilling. This helps keep the plastic from cracking / chipping when you're drilling into it. Try to use a coring drill bit instead of a paddle bit as well. Just tips I picked up from the Cyclewerkz folks...

[nitzer]

If you are going to do it, a cone bit will work better for plastic. Just do it slowly so the plastic doesn't melt too much. You will royally screw it up if you use a spade bit.

[DemonDuck]

Think cyclewerkz can do it?

[Fish R1]

A cone bit or (Uni bit) would work. Don't forget to tape the area being drilled on both sides to prevent cracking.

[DemonDuck]

Cyclewerkz did it for me and it took them like 2 whole minutes from the time I handed the plastic to them till they handed it back...... Let me just say CYCLEWERKZ FTW for anyone that didnt know. Scott and Dave are the MEN!!