finally got my ProGrips installed. I cut the old ones off and got the throttle side on no problem. Then I went to clutch side and realized you have to remove the bar end to get the grip on that side. Remembering how the shop took my last bike's bar ends off, I went to Lowe's and got the same mambo Kobalt screwdriver that has place for wrench on it. I also bought the 13MM wrench.
A couple taps with hammer and then tried screw driver and wrench and bar ends came off to my surprise! I saw the shop break a Snap-On screw driver before they tried the Kobalt one so I was impressed enough to buy one.
new grips
- Polokid69
- Club Member
- Posts: 3170
- Joined: Wed Jul 04, 2012 11:58 am
- Achievement count: 23
- Location: Fort worth
new grips
Current Bike:
KTM RC390
Previous Bikes:
2007 Kawasaki ZZR600
2012 Kawasaki Ninja 250R
2002 Kawasaki Ninja ZX6
2000 Kawasaki Ninja EX250
1983 Kawasaki GPZ550
1980 Yamaha RD400
1978 Yamaha DT 125
1978 Yamaha YZ 125
1975 Yamaha DT 100
KTM RC390
Previous Bikes:
2007 Kawasaki ZZR600
2012 Kawasaki Ninja 250R
2002 Kawasaki Ninja ZX6
2000 Kawasaki Ninja EX250
1983 Kawasaki GPZ550
1980 Yamaha RD400
1978 Yamaha DT 125
1978 Yamaha YZ 125
1975 Yamaha DT 100
1 post
• Page 1 of 1